![]() Make sure to use appropriate hardware for the size of the. If no studs are available, you can use wall anchors and toggle bolts to securely mount the shelf. ![]() When attaching shelves to plaster walls, it is important to screw the shelves into a stud in the wall. My current plan is to use 5/16' x 5 1/8' structural screws (rated as equivalent to a 1/2' lag bolt) to attach the cleats, two per cleat per stud, as shown in the diagram below. Your call - but I would try it in your position. Plaster walls are strong and can easily hold a shelf or wall-mounted shelving system. The wall is constructed of 3/4' drywall over lath and plaster (1/2' of plaster over 3/8' laths), with additional 1/4' and 3/4' boards between the laths and the studs. But it is certainly not 'satin' or anything - yuck.). And it has a beautiful glowing whiteness about it whilst still being matt (it is matt 'though not as pure matt as matt 'emulsion' would be. Even at a low angle I don't see patchiness or roller lines. It went on more easily than ordinary emulsion paint, and the second coat easier still - it wasn't being 'sucked' or drying too quickly, so was pleasant to use. Once dried, I filled in the uneven paint layers and then rolled on Sandtex ultra-smooth masonry paint ( was on cracking offer from our hosts.) using a short-pile roller. It can, however, require a bit more extra time and skill than. This stuff is mainly design to bind chalky and dusty/flaky surfaces, but I used it on my bathroom ceiling to seal the exposed plaster and improve the adhesion of the subsequent paint coats. If you have holes or cracks in your plaster walls or ceilings, repairing them isnt difficult. ![]() This is cheap stuff and watery - very easy to apply just roller it on. (So impressed that I also did an upstairs bathroom ceiling with Sandtex, and also the low wall and sloping ceiling of the adjoining bedroom).įor the bathroom - since I also had other issues with the cracking and small areas of peeling - after removing all the loose bits of paint I then rolled on Everbuild Stabilising Solution 406. This is your call, but this is what I did to our main bathroom which had long term issues with cracking and peeling ceiling paint, and the finish is really nice. (On that note, is there decent insulation above?) Lathe and plaster are usually pretty messy above after many years of dust and dirt accumulation, so possibly the plaster itself is 'discoloured' and this sort of percolates through to the paint layer from the normal moisture in a house (bearing in mind the air against the ceiling is always the warmest and hence the most 'damp' too. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |